Corvette V8-7.0L (2007)
3. Install the valve stem oil seal onto the guide.
1. Lubricate the valve guide and valve stem oil seal with clean engine oil.
2. Install the valve stem oil seal onto the valve stem. Push the seal down until the seal contacts the valve guide.
4. Install the valve spring (223) and cap (224) to the J 38606.
5. Compress the valve spring using the J 38606.
6. Install the valve spring (223) and cap (224) to the cylinder head.
7. Install the valve stem keys (225).
1. Use grease to hold the keys (225) in place and remove J 38606.
2. Make sure the keys (225) seat properly in the groove of the valve stem.
3. Carefully release the valve spring pressure, making sure the valve keys stay in place.
4. Remove the J 38606.
5. Tap the end to the valve stem with a plastic faced hammer to seat the keys, if necessary.
8. Install the valve rocker arm wear pads (234) - intake valves ONLY.
9. Disconnect and remove the air supply from the J 22794.
10. Remove the J 22794 from the spark plug hole.
11. Remove the air hose from the J 22794.
