Corvette V8-7.0L (2007)
1. Connect the HVAC control module electrical connections.
2. Install the HVAC control module to the I/P trim plate.
Notice: Refer to Fastener Notice.
3. Install the HVAC control module retaining screws.
Tighten the screws to 1.9 N.m (17 lb in).
4. Connect the electrical connectors to the HVAC control module.
5. Install the I/P accessory trim plate.
Important: Do not adjust any controls on the HVAC control module while the HVAC control module is self-calibrating. If interrupted,
improper HVAC performance will result.
The engine must be running for proper calibration to occur.
