Corvette V8-7.0L (2007)
3. Install the underbody retainers (2) on the mounting studs (1).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the chassis purge pipe (4) underbody retainer nuts (3).
Tighten the EVAP pipe retainer bracket nuts to 6 N.m (53 lb in).
5. Uncap the rear EVAP pipe.
6. Connect the rear EVAP pipe (1) to the chassis purge pipe (3).
7. Install the EVAP canister vent valve (2) to the bracket (1).
8. Install the driveline tunnel closeout panel.
9. Install the exhaust intermediate pipe.
10. Lower the vehicle.
11. Uncap the engine purge pipe.
