Corvette V8-7.0L (2007)
8. Using a DMM, verify the full and empty readings resistance reading of the fuel pump module. Turn the fuel tank upside down to achieve the full
tank reading.
*
Empty 40 ohms resistance
*
Full 250 ohms resistance
Important: Pull the jet line insert connector to ensure that the insert is properly attached.
9. Connect the jet line insert connector into the crossover tube to fuel tank opening.
10. If replacing the fuel pump module, install the FTP sensor (2).
11. Connect the FTP sensor harness connector (1).
12. Connect the fuel pump module harness connector (5).
13. Connect the EVAP purge line (4) from the fuel pump module.
14. Install the right fuel tank.
15. Connect the negative battery cable.
