Chevrolet Workshop Service and Repair Manuals

Backup Lamp Switch: Service and Repair

Backup Lamp Switch Replacement

Removal Procedure

1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the catalytic converters.
3. Disconnect the backup lamp switch electrical connector.

4. Remove the backup lamp switch.

Installation Procedure

Notice: Refer to Fastener Notice.

1. Install the backup lamp switch.

Tighten the backup lamp switch to 20 N.m (15 lb ft).

2. Connect the backup lamp switch electrical connector.
3. Install the catalytic converters.
4. Lower the vehicle.