Corvette V8-7.0L (2007)
Front Steering Knuckle: Service and Repair
Rear Suspension
Knuckle Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Disconnect the wheel speed sensor harness connector.
4. Disconnect the ESC position sensor link.
5. Remove the brake rotor.
6. Separate the outer tie rod end from the suspension knuckle. Refer to Tie Rod Replacement (Inner).
7. Remove the spindle nut retainer, the spindle nut and the washer.
8. Separate the suspension knuckle from the upper control arm. Refer to Rear Axle Upper Control Arm Replacement (Except RPO FE4) Rear Axle
Upper Control Arm Replacement (RPO FE4 (Z06)).
9. Separate the suspension knuckle from the lower control arm ball joint stud. Refer to Rear Axle Lower Control Arm Replacement.
10. Remove the suspension knuckle.
Installation Procedure
