Corvette V8-7.0L (2007)
Suspension Strut / Shock Absorber: Service and Repair
Front Suspension Shock Absorber
Shock Absorber Replacement (W/F55)
Shock Absorber Replacement (W/F55)
Tools Required
*
J 33432-A Transverse Spring Compressor
*
J 43822 Shock Support Tool
Removal Procedure
1. Disconnect the front shock ESC harness connector.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the tire and wheel assembly.
Important: The ESC connector seals to the upper shock shaft. If the upper shock shaft is damaged, the shock will need replacement.
4. Using only hand tools, remove the upper mounting nut, insulator retainer and insulator.
5. Remove the shock absorber lower mounting bolts and nuts.
6. Using a pry bar, compress the shock absorber from the bottom upward.
7. While the shock is in the compressed position, install the J 43822.
8. Remove the shock absorber from the vehicle.
9. Remove the J 43822 from the shock absorber.
10. Remove the insulator and insulator retainer from the shock absorber.