Corvette V8-7.0L (2007)
9. Remove the wheel hub mounting bolts.
10. Remove the hub and bearing assembly from the steering knuckle.
Installation Procedure
1. Install the hub and bearing assembly into the steering knuckle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the wheel hub mounting bolts.
Tighten the wheel hub mounting bolts to 130 N.m (96 lb ft).
3. Install the lower control arm ball stud to the steering knuckle.
4. Remove the jackstand.
5. Install the steering linkage outer tie rod ball stud to the steering knuckle.
6. Connect the wheel speed sensor electrical connector.
7. Install the stabilizer shaft link to the lower control arm.
8. Install the brake rotor and caliper.
9. Install the tire and wheel assembly.
10. Lower the vehicle.
