chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement|Page 11311 > < Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement|Page 11309
Page 1
background image

Fluid Line/Hose: Service and Repair
Transmission Fluid Cooler Hose/Pipe Connector Replacement (Upper Radiator)

Transmission Fluid Cooler Hose/Pipe Connector Replacement (Upper Radiator)

Removal Procedure

1. Remove the radiator support.

Important: The transmission oil cooler in held into position inside the radiator by the transmission oil cooler (TOC) fittings.

Service one TOC fitting at a time. Removal of both TOC fittings will cause the cooler tank to fall out of position and require radiator
removal to install the TOC fittings.

2. Disengage the plastic cap from the TOC fitting.

Pull the plastic cap back along the pipe.

3. Disconnect the TOC line from the TOC fitting.

4. Remove the TOC fitting from the radiator.

Installation Procedure

Notice: Refer to Fastener Notice.

1. Install the TOC fitting to the radiator.

Tighten the fitting to 18 N.m (13 lb ft).

Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement|Page 11311 > < Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement|Page 11309