Corvette V8-7.0L (2007)
8. Install the right motor mount.
Notice: Refer to Fastener Notice in Service Precautions.
9. Install the front transmission oil cooler line bolts.
Tighten the bolts to 12 N.m (106 lb in).
10. Inspect the transmission fluid level. Add fluid if necessary.
Transmission Fluid Cooler Upper Pipe Replacement - Rear
Transmission Fluid Cooler Upper Pipe Replacement - Rear
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the driveline tunnel closeout panel.
Important:
*
The front transmission oil cooler (TOC) inlet and outlet lines connect to the rear TOC inlet and outlet lines near the engine starter
motor.
*
Cap or plug the open TOC pipes immediately to prevent system contamination.
Disconnect the front transmission oil cooler (TOC) inlet and outlet lines from the rear TOC inlet and outlet lines.
Cap or plug the open TOC pipes.
