Corvette V8-7.0L (2007)
14. Route the park brake cables away from the suspension crossmember.
15. Remove the rear suspension position sensors if equipped.
16. Position an adjustable tall jack stand under the lower control arm near the ball joint location.
17. Raise the jack stand to reduce the transverse spring load on the lower control arm.
18. Remove the nut from the upper ball joint stud.
19. Separate the upper ball joint stud from the suspension knuckle. Refer to Rear Axle Upper Control Arm Replacement (Except RPO FE4) Rear Axle
Upper Control Arm Replacement (RPO FE4 (Z06)).
