Corvette V8-7.0L (2007)
Important: The spacer is specific for the bearing set and must be used in order to achieve the proper bearing preload. The pinion
bearings, spacer and housing/cage must be replaced as a set.
4. Remove the nut (1), bearing (2), spacer (3), and pinion shaft (5) from the housing/cage (4).
5. Install the J 42166 (3), or DT-48005 for Z06 models, onto the pinion shaft and bearing.
6. Use the J 42162 (2), the J 42166 (3) or DT-48005, and the J 8433 (1) or a hydraulic press in order to remove the bearing from the shaft.
