Corvette V8-7.0L (2007)
7. Install the bearing (1) onto the input shaft.
Install the bearing until completely seated against the flange of the input shaft.
8. Install the snap ring (2) into the groove of the input shaft.
9. Install a NEW slinger washer (1) onto the input shaft.
A properly installed slinger washer will have a gap of 1.5-2.5 mm (0.050-0.098 in) between the washer and the bearing face.
10. Install the input shaft, bolts, and washers to the coupling.
Tighten the coupling bolts to 90 N.m (66 lb ft).
