Corvette V8-7.0L VIN E (2006)
Liftgate Window Glass Weatherstrip: Service and Repair
Weatherstrip Replacement - Rear Lift Window Panel
Removal Procedure
1. Remove the rear compartment lift window panel and place the panel on a clean flat protective surface.
2. Remove the weatherstrip.
Pull the weatherstrip from the panel.
3. Remove the old weatherstrip retaining spring clips if replacing the clips.
4. Clean the panel surface removing all traces of the old weatherstrip.
Installation Procedure
1. Install a spring clip to the right and left side of the lift window panel aligning the lower edge of the clip with the upper edge of the auxiliary seal
(1).
2. Apply a thin continuous bead of weatherstrip sealant inside the forward lip of the lid.
3. Apply a thin bead of sealant, on the lower side of the lip, from the corners up approximately 400 mm (16 in).
4. Position the weatherstrip to the panel.
*
The curved surface of the weatherstrip must point up.
*
Work from each end toward the centerline.
