Corvette V8-7.0L VIN E (2006)
14. Install the steering linkage outer tie rod ends to the steering knuckles.
15. Connect the electronic suspension control (ESC) sensor links to the upper control arm, if equipped.
16. Connect the shock absorber solenoid electrical connector, if equipped.
17. Install the stabilizer shaft to the vehicle.
18. Install the tire and wheel assemblies.
19. Lower the vehicle.
20. Remove J 41803 and J 28467-B from the engine.
21. Install the generator.
22. Install the washer pump/reservoir.
23. Install the engine coolant temperature switch electrical connector.
24. Install the front headlamp electrical connector.
25. Connect the negative battery cable.
26. Perform a vehicle front end alignment. Refer to Measuring Wheel Alignment in Wheel Alignment.
