Corvette V8-7.0L VIN E (2006)
Note
The graphic above shows an example of the second design side rail link, which has a burr (at white arrow) on the metal casting. Removing/smoothing out
this burr will help protect the headliner from damage during top cycling.
Correction #1
Round off the inner top edge of the headliner trim and replace the headliner following the procedure below.
Correction #2
Remove the headliner and replace the four aluminum pins and retainers. There are two pins and two retainers per side. Also check the convertible top
linkage for sharp edges. Sand down all sharp edges and paint as necessary. Replace the headliner following the procedure listed below:
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table above.
Disclaimer
Part 1
Headliner Replacement Procedure