Corvette V8-7.0L VIN E (2006)
The inner (1) and outer (2) scoops are secured together with plastic tabs. The plastic tabs need to be released with a flat-bladed screwdriver or hook tool
prior to removal.
Remove the rear brake caliper inner air scoop and outer air scoop. Refer to Rear Brake Caliper Cooling Air Scoop Replacement in SI.
Wipe off any debris from the outer edge of the quarter panel around the air scoop.
Install the new design inner air scoop to the inner quarter body panel.
Install the new design outer air scoop from the outer quarter body panel and snap into the inner air scoop.
Install the rear brake caliper air cooling duct into the inner scoop.
Install the rear sound damping bag behind the rear brake caliper cooling duct.
Install the rear wheelhouse liner.
Install the rear wheelhouse liner fasteners and the 7 mm head screw for the rear brake caliper air cooling duct. Refer to Rear Wheelhouse Liner Panel
Replacement in SI.
Tighten the wheelhouse fasteners.
Tighten
Tighten the fasteners to 2 N.m (18 lb in).
Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in SI.
Repeat this entire procedure on the opposite side of the vehicle.
Lower the vehicle.
Parts Information
Warranty Information
