Corvette V8-7.0L VIN E (2006)
pillar.)
Unlatch and remove the roof.
With a small screw driver, unlock the four fingers of the guide from the striker and discard them. Remove the flocking tape from the new guides.
Install a piece of flocking tape under the brim of each of the guides (8 mm [0.31 in] wide by 50 mm [2 in] long) as shown above.
Install the new plastic guides into the striker.
Install the roof.
Correction 2
Install flocking tape and shim stock to the following areas
The A-pillar (shim stock)
At the end of the windshield garnish molding (flocking tape)
Remove the windshield garnish. Refer to Windshield Garnish Molding Replacement in SI.
Install a piece of 2 mm (.080 in) shim stock, 40 mm long by 10 mm wide (0.31 in by 1.6 in) to the A-pillar as shown above.