Corvette V8-7.0L VIN E (2006)
1. Apply a 50 mm (2 in) bead of sealant (1) GM P/N 12345097, or equivalent, down the middle of both the weatherstrip retainers at the upper rear
corner of the door opening.
2. Apply a bead of sealant (2) to the lower 50 mm (2 in) of the lock pillar weatherstrip retainer (1) and 50 mm (2 in) down the lock pillar.
3. Apply three parallel 50 mm (2 in) long beads of sealant (1) to the forward end of the door opening weatherstrip retainer and to the rear edge of the
reveal molding.
4. Remove the protective tape from the back of the weatherstrip.
5. Insert the weatherstrip into the weatherstrip retainers.
*
Start at the rear upper corner.
*
Insert the upper/outer edge of the weatherstrip first.
