Corvette V8-7.0L VIN E (2006)
Electronic Brake Control Module: Service and Repair
Electronic Brake Control Module (EBCM) Replacement
Removal Procedure
1. Turn the ignition switch to the OFF position.
2. Disconnect the electronic brake control module (EBCM) harness connector.
3. Remove the 2 insulator nuts (1).
4. Lift the EBCM/brake pressure modulated valve (BPMV) out of the bracket high enough to allow clearance to remove the insulator mounting bolt
and the EBCM.
5. Remove the insulator mounting bolt from the EBCM.
6. Remove the 6 EBCM to BPMV bolts.
7. Separate the EBCM from the BPMV by gently pulling apart until separated.
8. Carefully remove the seal. The seal may by reused if it is not cut or damaged.
Installation Procedure