Corvette V8-7.0L VIN E (2006)
Radiator Hose: Service and Repair
Radiator Inlet Hose Replacement
Radiator Hose Replacement - Inlet
^
Tools Required
-
J 38185 Hose Clamp Pliers
Removal Procedure
1. Drain the cooling system. Refer to Draining and Filling Cooling System (Static Fill) Draining and Filling Cooling System (GE 47716) .
2. Remove the radiator support.
3. Disengage tension on the radiator inlet hose clamp at the radiator using J 38185 .
4. Disconnect the radiator inlet hose from the radiator.
5. Disengage tension on the radiator inlet hose clamp at the water pump using J 38185 .
6. Disconnect the radiator inlet hose from the water pump.
7. Remove the radiator inlet hose from the vehicle.
Installation Procedure
1. Notice: Make sure the reference marks on the hoses and the radiator are lined up. A twist on the hose would place strain on the radiator fitting
which could cause the fitting to crack or break.
Important: Lubricate the inside diameters of the hose with clean coolant prior to installation.
Install the radiator inlet hose to the vehicle.