Corvette V8-7.0L VIN E (2006)
Drive Belt: Testing and Inspection
Drive Belt Chirping Diagnosis
Drive Belt Chirping Diagnosis
Diagnostic Aids
The chirping noise may be intermittent due to moisture on the drive belts or the accessory drive pulleys. in order to duplicate the customer concern, It
may be necessary to spray a small amount of water onto the drive belts. If spraying water on the drive belts duplicates the symptom, cleaning the
accessory drive pulleys may be the most probable solution.
A loose or improper installation of a body or suspension component, or other items on the vehicle may cause the chirping noise.
Test Description
The numbers below refer to the steps in the diagnostic table.
2. The chirping noise may not be engine related. This step is to verify that the engine is making the noise. If the engine is not making the noise do not
proceed further in this table.
3. The noise may be an internal engine noise. Remove the drive belts and operate the engine for a few seconds, this will verify if the chirping noise is
related to the drive belts or not. With the drive belts removed the water pump will not operate and the engine may overheat. Also diagnostic
trouble codes (DTC's) may set when the engine is operated with the drive belts removed.
4. Inspect the drive belts for signs of pilling. Pilling is the small balls, pills, or strings in the drive belt grooves caused by the accumulation of rubber
dust.
6. Misalignment of the accessory drive pulleys may be caused from improper mounting or incorrect installation of an accessory drive component, or
the pulley may be bent inward or outward from a previous repair. Test for a misaligned pulley using a straight edge in the pulley grooves across 2
or 3 pulleys. If a misaligned pulley is found refer to that accessory drive component for the proper removal and installation procedure for that
pulley.
10. Inspection of the fasteners can eliminate the possibility that a incorrect bolt, nut, spacer, or washer was installed.
12. Inspection the accessory drive pulleys should include inspecting for bends, dents or other damage to the pulleys that would prevent the drive belts
from seating properly in the pulley grooves or on the smooth surface of a pulley when the back side of the drive belt is used to drive the pulley.
14. Replacing the drive belts when it is not damaged or there is not excessive pilling will only be a temporary repair.
