Corvette V8-7.0L VIN E (2006)
1. Connect the HVAC control module electrical connections.
2. Install the HVAC control module to the I/P trim plate.
3. Install the HVAC control module retaining screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.9 N.m (17 lb in).
4. Connect the electrical connectors to the HVAC control module.
5. Install the I/P accessory trim plate.
6. Start and allow the engine to run for at least one minute.
IMPORTANT:
-
Do not adjust any controls on the HVAC control module while the HVAC control module is self-calibrating. If interrupted, improper HVAC
performance will result.
-
The engine must be running for proper calibration to occur.
