chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Electrical - Dead Battery After Extended Storage|Page 348 > < Global Positioning System Module|Locations|Page 339
Page 1
background image

Keyless Entry Module: Customer Interest
Electrical - Dead Battery After Extended Storage

Bulletin No.: 07-06-03-001B

Date: March 21, 2007

TECHNICAL

Subject:
Dead Battery, No Crank/No Start (Reprogram Remote Control Door Lock Receiver (RCDLR))

Models:
2005-2007 Cadillac XLR (Including XLV-V)
2005-2007 Chevrolet Corvette (Including Z06)

Built Prior to the VIN Breakpoints shown.

Supercede:

This bulletin is being revised to update the correction information. Please discard Corporate Bulletin Number 07-06-03-001A (Section 06 -
Engine/Propulsion System).

Condition

Some customers may comment on a dead battery after the vehicle has been parked for a extended period of time.

Typically, the battery will last approximately two weeks, depending on the initial state of battery charge.

Cause

A software anomaly within the remote control door lock receiver (RCDLR) causes an additional 30 mA draw on the battery when passive locking is
enabled and the vehicle is parked.

Correction

Use the Pass-Thru method when programming and select "Replace and Reprogram ECU."

A new calibration has been released to correct this condition. Reprogram the RCDLR using SPS. This new service calibration is available on TIS2WEB.

On Corvette models, prior to reprogramming, remove the Radio/S-Band/VICS 15-amp fuse and the HVAC/PWR SND 10-amp fuse from the I/P
electrical center (passenger floor). Also, the ignition must be in the "Key On Engine Off" mode.

If the programming does not finish successfully and the RCDLR appears to be in a "locked-up" state, DO NOT turn off the ignition, it can be reset by
removing the RCDLR fuse (# 11 in the UBEC) for at least 30 seconds and reinstalling it. If the ignition was turned to OFF after the "locked up"
condition occurred, its possible to continue programming by adding the VIN manually in TIS.

Tip

Transmitter programming and tire pressure learn procedures are NOT necessary after this reprogram.

Electrical - Dead Battery After Extended Storage|Page 348 > < Global Positioning System Module|Locations|Page 339