Corvette V8-7.0L VIN E (2006)
6. Remove the SDM fuse from the I/P fuse block.
7. Open left/driver door and remove the door trim panel. Refer to Trim Panel Replacement - Driver Door in Doors.
8. Locate left side impact sensor (SIS) (1).
9. Remove the connector position assurance (CPA) (3) from SIS connector (2).
10. Remove the SIS connector (2) from the SIS (1).
ENABLING PROCEDURE
1. Place the ignition in the OFF position.
2. Connect the SIS connector (2) to the SIS (1).
3. Connect the CPA (3) to the SIS connector (2).
4. Install the door trim panel.
