Corvette V8-7.0L VIN E (2006)
Tires: Technical Service Bulletins
Tires - Run Flat/Zero Pressure Tire Info./Service
Bulletin No.: 05-03-10-019
Date: December 06, 2005
INFORMATION
Subject:
Information on Run Flat, Zero Pressure or Extended Mobility Tires (EMT) and Unique Servicing Techniques
Models:
2004-2006 Cadillac CTS-V
2005-2006 Cadillac XLR
2006 Cadillac XLR-V, STS-V
1994-2006 Chevrolet Corvette
Supercede:
This bulletin is being revised to add vehicles, model years, tire manufacturers, and additional information. Please discard Corporate Bulletin Number
33-35-02A.
Tire Manufacturers
GM currently uses tires from three manufacturers that can continue to be driven on while completely deflated. Each brand has their own slogan for this
capability.
^
Goodyear - Extended Mobility Tire (EMT)
^
Michelin - Run Flat
^
Pirelli - Zero Pressure (ZP)
Characteristics and Added Capability
The tires above can be operated at up to 89 km/h (55 mph) for 160 km (100 mi) with zero air pressure. All vehicles originally installed with this style of
tire are factory-equipped with a tire pressure monitoring system (TPM). Each wheel position has a sensor which transmits inflation pressures to a
receiver that displays actual pressures to the driver. This system immediately alerts the driver of a loss of air pressure in any tire, as it is possible to drive
with zero air pressure and not notice any difference in vehicle handling.
Mounting and Dismounting
Due to the unique reinforced sidewall construction of this type of tire some special servicing techniques are required. This mainly pertains to mounting
and dismounting the tire from the wheel.
Caution:
Inflation pressure exceeding 276 kPa (40 psi) may be required to seat the beads during mounting. To prevent serious injury, only specially trained
tire technicians should mount or dismount these tires. A tire inflation safety cage and clip-on air hose must be used. A rim clamp/European style tire
changer is also recommended to mount or dismount run-flat type tires.
If a "run-flat" style tire must be dismounted for non-tire related reasons such as a wheel, valve, or sensor replacement, it is recommended that the job be
sublet to an authorized tire service facility if your dealership DOES NOT have qualified personnel and the necessary equipment described above.
Extreme care must be taken that the tire pressure warning sensor and 0-ring inside the tire are not damaged. Some tire changing equipment companies
such as Coats* and Hunter* have put together a procedure booklet for these tires.
Caution:
Even when using a safety cage to seat the tire bead, do not exceed 552 kPa (80 psi). If the bead does not seat by 552 kPa (80 psi), you should deflate
the tire and change the position of the tire in relation to the wheel. Use of tire lubricant is also advisable.
*We believe these sources and their equipment to be reliable. There may be additional manufacturers of such equipment. General Motors does not
endorse, indicate any preference for, or assume any responsibility for the products or equipment from these firms, or for any such items which may be
available from other sources.
