Corvette V8-7.0L VIN E (2006)
^
The clearance between each of the three pressure plate lug rivet heads (1) and flywheel step must be 6 mm (15/64 inch) or greater at all three
locations. If the clearance between the pressure plate lug rivet head (1) and the flywheel step is 6 mm (15/64 inch) or greater at all three
locations, the flywheel does not require replacement. Reassemble the vehicle components and proceed to step 5. Refer to Clutch Assembly
procedure for the 6.0L (LS2) engine or 7.0L (LS7) engine in SI.
^
If the clearance between the pressure plate lug rivet head (1) and the flywheel step is greater than 0.05 mm (0.002 inch), but is less than 6 mm
(15/64 inch) at any of the three pressure plate lug rivet head (1) and flywheel step locations, replace the flywheel only. Perform service
procedure steps 2, 3 and 5. Refer to information in third bulletin point before replacing the flywheel.
