Corvette V8-7.0L VIN E (2006)
^
If the clearance between the pressure plate plug rivet head (1) and the flywheel step is greater than 0.05 mm (0.0002 inch), but is less than 6
mm (15/64 inch) at any of the three pressure plate plug rivet head (1) and flywheel step locations, replace the flywheel only Perform service
procedure steps 2, 3 and 5. Refer to information in third bulletin point before replacing the flywheel.
^
If there is less than 0.05 mm (0.0002 .inch) clearance between any of the pressure plate plug rivet heads (1) and flywheel step locations, the
flywheel and clutch assembly must be replaced. Perform service procedure steps 2-5.
