Corvette V8-7.0L VIN E (2006)
^
If there is less than 0.05 mm (0.002 inch) clearance between any of the pressure plate lug rivet heads (1) and flywheel step locations, the
flywheel and clutch assembly must be replaced. Perform service procedure steps 2-5.
Important:
Remove the clutch pressure plate bolts in the sequence shown, starting with the number one and following in numerical order.
4.
Remove the flywheel. Refer to Engine Flywheel Replacement and Engine Flywheel Removal procedures for the 6.0L (LS2) engine or 7.0L (LS7)
engine in SI.
Important:
During the powertrain build process, balance weights may be added to the flywheel. Install the same size balance weights onto the new
flywheel in the same location as the old flywheel. Apply Threadlocker - Red. GM P/N 12345382 (Canadian P/N 10953489). or equivalent. to
balance weights before pressing them into the flywheel.
