Corvette V8-7.0L VIN E (2006)
23. Install the driveline support assembly to engine flywheel housing bolts.
^
Tighten the driveline support assembly to engine flywheel housing bolts to 50 Nm (37 ft. lbs.).
24. Install the wiring harness to the wiring harness retainer along the top of the transmission.
25. SLOWLY raise the driveline to approximately 51 mm (2 inch) BELOW the final installed height.
26. Remove the caps from the front of the transmission oil cooler pipes and remove the plugs from the junction fittings at the engine flywheel housing.
27. ALIGN and HAND-START, then tighten ONLY by hand to seat the transmission oil cooler pipes to the junction fittings at the engine flywheel
housing.
^
Tighten the transmission oil cooler pipes to junction fittings at engine flywheel housing to 27 Nm (20 ft. lbs.).
28. Install the transmission wiring harness to LH side of transmission case retaining bolt.
^
Tighten the transmission wiring harness to LH side of transmission case retaining bolt to 2.5 Nm (22 inch lbs.).
29. Connect the park/neutral position switch electrical connectors.
30. Connect the transmission wiring harness 20-way connector. Align the arrows on each half of the connector.
