Corvette V8-7.0L VIN E (2006)
19. SLOWLY seat the driveline to the engine flywheel housing while maintaining the proper angle of the driveline.
20. Reposition the wiring harness bracket from near the driveline tunnel wall to align with the appropriate driveline support assembly bolt hole.
21. Install the 5 driveline support assembly to engine flywheel housing bolts.
^
Tighten the driveline support assembly to engine flywheel housing bolts to 50 Nm (37 ft. lbs.).
22. Install the wiring harness to the wiring harness retainer along the top of the transmission.
23. SLOWLY raise the driveline to approximately 51 mm (2 inch) BELOW the final installed height.
24. Connect the transmission fluid temperature sensor electrical connector, if equipped.
25. Connect the gear select (skip shift) solenoid electrical connector.
26. Connect the reverse lockout solenoid electrical connector.
