Cruze L4-1.4L Turbo (2011)
15. Inspect the caliper bracket (5). If the brake caliper bracket (5) is bent, cracked, or damaged, it requires replacement.
16. Inspect the brake caliper guide pins (3) for freedom of movement, and inspect the condition of the guide pin boots (4). Move the brake caliper
guide pins (3) inboard and outboard within the brake caliper bracket (5), without disengaging the slides from the boots (4), and observe for the
following:
*
Restricted caliper guide pin movement
*
Looseness in the brake caliper mounting bracket
*
Seized or binding caliper guide pins
*
Split or torn boots
17. If any of the conditions listed are found, the brake caliper guide pins (3) and/or boots (4) require replacement.
Installation Procedure
1. Install the brake caliper bracket (1) to the steering knuckle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the NEW brake caliper bracket bolts (2) and tighten to 100 Nm (74 lb ft) + 60° - 75°
