Cruze L4-1.4L Turbo (2011)
Note: Discard the brake caliper bracket bolts.
6. Remove the brake caliper bracket bolts (1).
7. Remove the rear brake caliper bracket.
8. Inspect the brake mounting and hardware. Refer to Rear Brake Caliper Hardware Replacement (See: Rear Brake Caliper Hardware Replacement
).
9. Inspect the brake caliper bracket.
10. Replace the brake caliper bracket if cracked or damaged.
Installation Procedure
1. Install the brake caliper bracket.
Caution: This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a
standard tap. If a standard tap is used, damage to the joint threads will occur.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the NEW brake caliper mounting bracket bolts (1) and tighten to 100 Nm (74 lb ft) + 60° - 75°.
