Cruze L4-1.4L Turbo (2011)
8. Install the radiator surge tank (1).
9. Install the radiator surge tank clip (2).
10. Program the EBCM. Refer to Electronic Brake Control Module Programming and Setup (See: Testing and Inspection/Programming and
Relearning/Electronic Brake Control Module Programming and Setup).
11. Perform the diagnostic system check - Vehicle. Refer to Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and
Diagnostic Overview/Diagnostic System Check - Vehicle).
12. Calibrate the brake pressure modulator valve pressure sensor. Refer to Brake Pressure Modulator Valve Pressure Sensor Calibration (See:
Testing and Inspection).
Caution: When adding fluid to the brake master cylinder reservoir, use only GM approved or equivalent DOT-3 brake fluid from a clean, sealed
brake fluid container. The use of any type of fluid other than the recommended type of brake fluid may cause contamination which could result in
damage to the internal rubber seals and/or rubber linings of hydraulic brake system components.
13. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair/Hydraulic
Brake System Bleeding (Manual))Hydraulic Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair/Hydraulic Brake
System Bleeding (Pressure)).
14. Center the steering angle sensor. Refer to Steering Angle Sensor Centering (See: Sensors and Switches/Sensors and Switches - Steering and
Suspension/Sensors and Switches - Steering/Steering Angle Sensor/Service and Repair/Procedures).