Cruze L4-1.4L Turbo (2011)
4. Rotate the crankshaft balancer in engine rotation direction until the 180° opposite marking (2) aligns with the marking (1) on the engine front
cover.
5. Lower the vehicle.
Note: Wheels must contact the ground.
6. Block the engine by shifting the 5. gear (MT) or park position (AT) and applying the park brake.
7. Transfer the EN-6086-15 - pneumatic adapter from cylinder 4 to the spark plug bore of cylinder 2.
8. Apply air pressure to cylinder 2.
9. Transfer the EN-6086-7 - lever to the intake side of cylinder 2.
10. Replace the EN-6086-200-1 - mounting piece with the EN-6086-11 - demounting piece.
11. Remove the intake valve keys, intake valve spring retainers, intake valve springs and the intake valve stem oil seals of cylinder 2 as described
above.
Intake Valve Stem Oil Seal Installation Cylinder 2
1. Transfer the EN-6086-7 - lever to the exhaust side of cylinder 2.
2. Replace the EN-6086-11 - demounting piece with the assembled EN-6086-200-1 - mounting piece (1).
3. Install the intake valve keys, intake valve spring retainers, intake valve springs and the intake valve stem oil seals of cylinder 2 as described above.
Exhaust Valve Stem Oil Seal Removal And Installation Cylinder 2
Replace the exhaust valve keys, exhaust valve spring retainers, exhaust valve springs and the exhaust valve stem oil seals of cylinder 2 as described
above.
Intake Valve Stem Oil Seal Removal Cylinder 3
1. Release the air pressure from cylinder 2.
2. Transfer the EN-6086-15 - pneumatic adapter from cylinder 2 to the spark plug bore of cylinder 3.
3. Apply air pressure to cylinder 3.
4. Transfer the EN-6086-7 - lever to the intake side of cylinder 3.
5. Replace the EN-6086-200-1 - mounting piece with the EN-6086-11 - demounting piece.
6. Remove the intake valve keys, intake valve spring retainers, intake valve springs and the intake valve stem oil seals of cylinder 3 as described
above.
Intake Valve Stem Oil Seal Installation Cylinder 3
1. Transfer the EN-6086-7 - lever to the exhaust side of cylinder 3.
2. Replace the EN-6086-11 - demounting piece with the assembled EN-6086-200-1 - mounting piece.
3. Install the intake valve keys, intake valve spring retainers, intake valve springs and the intake valve stem oil seals of cylinder 3 as described above.
