Cruze L4-1.4L Turbo (2011)
3. Tighten the bearing/hub bolts (1) in 3 passes. Use the EN-45059 - angle meter.
*
First pass to 90 Nm (66 lb ft)
*
Second pass to 60°
*
Third pass to 15°
4. Install the wheel drive shaft at the front wheel bearing/hub. Refer to Front Wheel Drive Shaft Replacement - Left Side (See: Transmission and
Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Front Wheel Drive Shaft Replacement - Left Side) or Front
Wheel Drive Shaft Replacement - Right Side (See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service
and Repair/Front Wheel Drive Shaft Replacement - Right Side).
5. Install the wheel speed sensor (1) to the steering knuckle.
6. Install the wheel speed sensor screw (2) and tighten to 6 Nm (53 lb in).
7. Install the brake rotor. Refer to Front Brake Rotor Replacement (See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service
and Repair/Removal and Replacement/Front Brake Rotor Replacement).
8. Lower the vehicle.