Cruze L4-1.4L Turbo (2011)
1. Install the engine control module (3) to the engine control module bracket (4).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the 4 nuts (1) and tighten to 9 Nm (80 lb in).
3. Clip the engine control module bracket (4) to the battery tray.
4. Connect the 2 wiring harness plug (2) to the engine control module (3).
5. Connect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Negative/Service and Repair/Battery Negative Cable Disconnection and Connection).
6. Program the ECM. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning).
