Cruze L4-1.4L Turbo (2011)
Circuit Protection - Fusible Links
Circuit Protection - Fusible Links
Special Tools
EL 39200 - Digital Multimeter (DMM)
For equivalent regional tools, refer to Special Tools (See: Power and Ground Distribution/Tools and Equipment).
Fusible link is wire designed to melt and break continuity when excessive current is applied. It is often located between or near the battery and starter or
electrical center. Use a continuity tester or a Digital Multimeter (DMM) at each end of the wire containing the fusible link in order to determine if it is
broken. If broken, it must be replaced with fusible link of the same gauge size.
Repairing a Fusible Link
Note: Fusible links cut longer than 225 mm (approximately 9 in) will not provide sufficient overload protection.
Flat Wire Repairs
Flat Wire Repairs
The flat wire within the flex wiring harness is not serviceable. If an open or short exists within the flex wiring harness the complete harness must be
replaced.
GMLAN Wiring Repairs
GMLAN Wiring Repairs
Special Tools
*
EL-38125-10 - Splice Sleeve Crimping Tool
*
J 38125-5 - Ultra Torch Special Tool
*
DuraSeal splice sleeves
*
A wire stripping tool
