Cruze L4-1.4L Turbo (2011)
14. Disconnect electrical connector (1) transmission control module (TCM), then unclip the connector from the transmission.
15. Remove wiring harness starter motor from transmission. Remove bolt from retainer on valve body cover. Unclip wiring harness from retainer on
valve body cover and range selector cable bracket.
16. Remove the control valve body cover bolts (1).
17. Remove the control valve body cover (2).
18. Remove the control valve body cover gasket (3).
Caution: Support the control solenoid valve assembly around the connector when removing the seal. Excessive pulling force can damage the
internal electrical connections.
19. Remove the control valve body cover wiring connector hole seal (4).
20. Remove all traces of the old gasket material. Clean the transmission case and control valve body cover gasket surfaces.
Installation Procedure
