Cruze L4-1.4L Turbo (2011)
Caution: Do not cut through the wheel drive shaft inboard or outboard boot during service. Cutting through the boot may damage the sealing
surface of the housing and the tripot or the constant velocity joint bushing. Damage to the sealing surface may lead to water and dirt intrusion and
premature wear of the constant velocity joint.
3. Use a flat-bladed tool, remove the boot clamp (2) from the constant velocity (CV) joint (1) and the boot (3).
4. Using a pair of side cutters, remove and discard the boot clamp (4) from the boot (3) and the wheel drive shaft (5). Replace with NEW clamps.
5. Using a block of wood and a hammer, remove the CV joint (2) from the wheel drive shaft (1).
