Cruze L4-1.4L Turbo (2011)
4. Using a block of wood and a hammer, install the CV joint on the wheel drive shaft (1).
5. Install the boot clamp (4) on the boot (3) and the wheel drive shaft (5).
6. Install the boot clamp (2) on the boot (3) and the CV joint housing (1).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
7. Crimp the eared clamp using the CH-804 - tensioner (1), and a torque wrench. Tighten the eared clamp to 25 Nm (19 lb ft).
8. Remove the wheel drive shaft from the bench vise.
9. Move the CV joint in a circular motion 4 to 5 times to distribute the lubricant.
10. Install the left or right wheel drive shaft, refer to Front Wheel Drive Shaft Replacement - Left Side (See: Service and Repair/Front Wheel Drive
Shaft Replacement - Left Side) or Front Wheel Drive Shaft Replacement - Right Side (See: Service and Repair/Front Wheel Drive Shaft
Replacement - Right Side).
