EL Camino V6-229 3.8L (1982)
Brake Caliper: Service and Repair
Bendix Single Piston Sliding Caliper
Caliper Removal
Fig. 2 Bottoming position in bore
Fig. 3 Removing caliper support key
Removing Caliper From Disc
1.
Siphon two-thirds of brake fluid from master cylinder reservoir serving front disc brakes.
2.
Raise vehicle, support on jack stands and remove front wheels.
3.
Bottom the caliper piston in bore. Insert a screwdriver between inboard shoe and piston, then pry piston back into bore. The piston can also be
bottomed in the bore with a large C-clamp, Fig. 2.
4.
Remove support key retaining screw.
5.
Drive caliper support key and spring from steering knuckle with a suitable drift and hammer, Fig. 3.
6.
Lift caliper from anchor plate and off rotor, Fig. 4. Hang caliper from coil spring with wire. Do not allow caliper to hang from brake hose.