EL Camino V6-229 3.8L (1982)
![background image](/chevrolet/el_camino/v6-229_3.8l/Page-1225001.png)
Ball Joint: Service and Repair
1.
Raise vehicle, then support lower control arm with suitable jack.
2.
Remove cotter pin from upper ball stud, then loosen stud nut approximately two turns.
3.
Separate ball joint from steering knuckle using suitable tool, then remove stud nut.
4.
Center punch rivet heads, then drill out rivets and remove ball joint from control arm.
5.
Reverse procedure to install. Torque stud nut to 50 ft. lbs. on 1980---87 10/1500 Series and 1985---87 G20/2500 Series, 65 ft. lbs. on 1980---84
Caballero and El Camino, 52 ft. lbs. on 1985---87 Caballero and El Camino, or 90 ft. lbs. on all other models. If cotter pin does not align with stud
nut, tighten nut an additional amount until cotter pin can be installed. Never loosen stud nut when installing cotter pin.