EL Camino V8-267 4.4L (1982)
FIGURE 4 - FILL PLUG
14.
With fill plug in fill hole, insert tool J-34118 into fill plug (Figure 4). Tighten tool to 35 ft.lbs. (47 N-m) and make sure plug outer rim is flat and
tight against converter shell. Set new converter aside.
15.
Remove lower bed fill hole plug from old converter using procedure described in Step 6.
FIGURE 1 - CONVERTER BELT FLANGE
16.
Hold converter over a clean pan (J-34155-2) and empty catalyst beads by shaking and tapping converter belt flange (Figure 1) with rubber mallet.
