EL Camino V8-305 5.0L (1984)
5. Tighten lock nuts at shift rod swivels and remove gage pin.
6. Place transmission control lever in reverse position and the ignition switch in "Lock" position. Loosen lock nut at back-drive control rod swivel, then
pull rod downward slightly to remove slack in the column mechanism, then tighten the lock nut.
7. Check interlock control. The ignition switch should move freely to and from the "Lock" position.
8. Check transmission shift operation and if satisfactory, lower vehicle.
4 Speed
Description
Refer to image, then follow the same procedure as outlined under "3-Speed Floor Shift Linkage, Adjust".
