Equinox AWD V6-3.4L (2008)
Notice: Refer to Fastener Notice.
2. Install the air temperature actuator screws to the HVAC module.
Tighten the screws to 1.5 N.m (13 lb in).
3. Connect the electrical connector to the air temperature actuator.
Important: Any time an actuator or the HVAC control module is replaced, the HVAC control module must be calibrated to ensure
proper air distribution.
4. Calibrate the actuators. Refer to Actuator Recalibration. See: Testing and Inspection/Programming and Relearning
5. Cycle the ignition and verify proper operation.
6. Install the instrument panel compartment.
