Equinox AWD V6-3.4L (2008)
2. Loosen both inner tie rod jam nuts.
Important: The inner tie rod must rotate freely from the boot seal surface. Do not allow the boot to rotate.
3. Loosen the inner tie rod seal to boot surface.
4. Use a wrench on the tie rod flats to increase or decrease the toe angle specifications. Refer to Wheel Alignment Specifications (See:
Specifications) .
Notice: Refer to Fastener Notice .
5. Tighten the inner tie rod jam nuts.
Tighten the jam nuts to 60 N.m (44 lb ft).
6. Inspect the toe angle to ensure proper adjustment and adjust as necessary.
Rear Camber Adjustment
Rear Camber Adjustment
1. Loosen the upper control arm-to-frame fastener enough to allow movement.
Important: The frame of the vehicle is slotted, turning the cam nut will move the camber in to the designated location.
2. Rotate the upper control arm-to-frame fastener in the direction necessary to the correct the camber measurement.
3. Snug the upper control arm-to-frame fastener, do not tighten at this time.
4. Reinspect the rear camber specifications and adjust as necessary.
Notice: Refer to Fastener Notice .
