Equinox AWD V6-3.4L (2008)
3. Release and slide the thermal bypass pipe hose clamps (2) away from the hose connections.
4. Remove thermal bypass hose (1).
Installation Procedure
1. Apply engine coolant to the bypass hose in order to ease installation.
2. Install the thermal bypass pipe hose (1).
3. Position the thermal bypass pipe hose clamps (2) over the hose end connections.
4. Fill the cooling system. Refer to Cooling System Draining and Filling (LNJ Static Fill) (See: Engine, Cooling and Exhaust/Cooling
System/Service and Repair)Cooling System Draining and Filling (LNJ GE 47716 Fill) (See: Engine, Cooling and Exhaust/Cooling
System/Service and Repair)Cooling System Draining and Filling (LY7 Static Fill) (See: Engine, Cooling and Exhaust/Cooling System/Service
and Repair)Cooling System Draining and Filling (LY7 GE 47716 Fill) (See: Engine, Cooling and Exhaust/Cooling System/Service and Repair) .
5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (See: Powertrain Management/Fuel Delivery and Air
Induction/Fuel Injector/Service and Repair/Removal and Replacement/Fuel Injector Sight Shield Replacement) .
Thermal Bypass Pipe Replacement
Thermal Bypass Pipe Replacement
Tools Required
J 21882 Oil Suction Pipe Installer
Removal Procedure
1. Drain the engine coolant. Refer to Cooling System Draining and Filling (LNJ Static Fill) (See: Engine, Cooling and Exhaust/Cooling
System/Service and Repair)Cooling System Draining and Filling (LNJ GE 47716 Fill) (See: Engine, Cooling and Exhaust/Cooling