Equinox AWD V6-3.4L (2008)
Fuel Tank Unit: Service and Repair
Secondary Fuel Tank Module Replacement
Secondary Fuel Tank Module Replacement
Tools Required
J39765-A Fuel Sender Lock Ring Tool
Removal Procedure
Caution: Whenever fuel line fittings are loosened or removed, wrap a shop cloth around the fitting and have an approved container available
to collect any fuel.
Notice: Clean all fuel pipe and hose connections and surrounding areas before disassembling to avoid possible contamination of the fuel system. Spray
the fuel pump module cam-lock ring tang with penetrating oil prior to attempting removal.
Important: A NEW fuel tank module seal is necessary each time the fuel tank module is serviced. Obtain a NEW seal prior to beginning this
service procedure.
1. Remove the fuel tank.
2. Disconect the EVAP vent line quick connect.
Notice: To prevent retainer damage, do not attempt to remove the retainer with a 12 in. or shorter ratchet/breaker bar.
3. Use the J39765-A and remove the fuel pump module retaining ring.
4. Carefully raise the fuel pump module until the electrical connector and suction port tube can be disconnected.
