Equinox AWD V6-3.4L (2008)
Ignition Control Module: Service and Repair
Ignition Control Module Bracket Replacement
Ignition Control Module Bracket Replacement
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the injector sight shield.
3. Disconnect the ignition coil/control module electrical connectors.
4. Remove the spark plug wire retainer (1) from the ignition control module bracket.
5. Remove the 4 bolts securing the ignition coil/control module to the ignition control module bracket.
6. Position the ignition coil/control module aside out of the way.
7. Remove the bolt (3) from the fuel injector wire harness bracket (4) and positive crankcase ventilation (PCV) valve fresh air tube retainer.
8. Remove the engine wire harness retainers from the ignition control module bracket studs (5).
9. Remove the nut (1) retaining the heater outlet pipe.
10. Lift pipe up slightly to gain access for the removal of the 2 ignition control module bracket bolts.
